The purpose of this study has been to investigate the effects of TiAlN functional coatings in cryo-tribological pin-on-disk experiments. Nowadays, the introduction of new machining technologies for chip removal, both at high speed and in cryogenic conditions, is posing new challenges and opening new horizons to research. As a matter of fact, that in this technology needs to focus on the choice of workpiece materials to be machining and tools coatings used. For the latter, the wear phenomenon has been studied employing pins-on-disk (made by nickel-based alloys) under a liquid nitrogen jet flows simulating cryogenic machining. The coatings used have been of two different types: the coating C1 is a ZrTiAlN quaternary, while the coating C2 is a TiAlN/ZrN. The films were deposited with processes developed by the ENEA Brindisi laboratory using a dual magnetron sputtering and HiPPMS physical deposition technique. The wear measures were acquired employing a full factorial design with two factors: i.e., the test conditions (DRY or CRYO) and the pin coatings (not coated NC, coating C1 or C2). The number of tests was 12 since 2 were the replications. Based on preliminary experimental results, it can be stated that there is a type of coating, i.e., TiAlN/ZrN, that allows for high processing speed, high material removal, and a considerable increase in tool life.
Validation of TiAlN functional coatings through cryo-tribological characterization using a pin-on-disk experiment
Papadia G.
2021-01-01
Abstract
The purpose of this study has been to investigate the effects of TiAlN functional coatings in cryo-tribological pin-on-disk experiments. Nowadays, the introduction of new machining technologies for chip removal, both at high speed and in cryogenic conditions, is posing new challenges and opening new horizons to research. As a matter of fact, that in this technology needs to focus on the choice of workpiece materials to be machining and tools coatings used. For the latter, the wear phenomenon has been studied employing pins-on-disk (made by nickel-based alloys) under a liquid nitrogen jet flows simulating cryogenic machining. The coatings used have been of two different types: the coating C1 is a ZrTiAlN quaternary, while the coating C2 is a TiAlN/ZrN. The films were deposited with processes developed by the ENEA Brindisi laboratory using a dual magnetron sputtering and HiPPMS physical deposition technique. The wear measures were acquired employing a full factorial design with two factors: i.e., the test conditions (DRY or CRYO) and the pin coatings (not coated NC, coating C1 or C2). The number of tests was 12 since 2 were the replications. Based on preliminary experimental results, it can be stated that there is a type of coating, i.e., TiAlN/ZrN, that allows for high processing speed, high material removal, and a considerable increase in tool life.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
